Step 1: Using your computer, lay out the IDs in A4 size document, as the PVC film has the same size. It will be good to place all the fronts of the IDs on one side (lengthwise) and the backs on the other side. Print the images on the printable side of the transparent PVC films.
Step 2: Cut the PVC film lengthwise. Put a pair of printable sheets together and tape one edge to align the images. Make sure that the images on this pair would be the front and back of the ID. Set aside.
Step 3: Get the adhesive part of the PVC film and peel off the plastic covering both sides. Put the adhesive in between the printed sheets.
Step 4: Preheat the laminator machine for a few minutes and set it to 120 0C.
Step 5: Once the green light is on, start laminating the PVC film. The machine has three buttons: the Plastic Seal, Clockwise and Start buttons. The start button should be pressed when laminating. The Plastic Seal button, however, should be turned off if you\\\'re doing cold lamination.
Step 6: After laminating the PVC, cut it into individual ID pieces using the mold cutter.